Литература по нефтяной
и газовой промышленности

Carl Gatlin: Petroleum engineering. Drilling and well completions

Авторы: Carl Gatlin

Название: Petroleum engineering. Drilling and well completions

Формат: PDF

Размер: 32,7 Mb

Год издания: 1960

 

Contents
Chapter 1. The Nature of Petroleum
1.1. Chemical composition.
1.2. Properties of liquid petroleum.
1.3. Gaseous petroleum (natural gas).
1.4. The gas law.
1.5. Sample problems.
 
Chapter 2. Concepts of Petroleum Geology and Basic Rock Properties
2.1. Requirements for commercial oil accumulations.
2.2. Subsurface pressures.
2.3. Subsurface temperatures.
2.4. Sample problems.
 
Chapter 3. Petroleum Exploration Methods and General Leasing Practices
3.1. Direct indications.
3.2. Geological exploration methods.
3.3. Geophysical exploration.
3.4. leasing and scouting activities.
 
Chapter 4. Cable Tool Drilling
4.1. Introduction.
4.2. Equipment and basic technique.
4.3. Drilling technique.
4.4. Relative merits of cable tool drilling.
4.5. Current applications of cable tools.
 
Chapter 5. Rotary Drilling: General Method and Equipment
5.1. Introduction and basic operations.
5.2. Basic rig components.
 
Chapter 6. The Composition, Functions, and General Nature of Rotary Drilling Fluids
6.1. Introduction.
6.2. Testing of drilling fluids.
6.3. Basic function* of the drilling fluid.
6.4. Composition and nature of common drilling muds.
6.3. Drilling hazard* dependent on mud control.
6.6. Drilling mud calculations.
6.7. Field maintenance of mud systems.
6.8. Air, natural gas, and aerated mud as drilling fluids.
 
Chapter 7. Rotary Drilling Hydraulics
7.1. Introduction.
7.2. Newtonian fluid flow calculations.
7.3. Plastic fluid flow calculations.
7.4. Pressure drop across bit nozzles and watercourses.
7.5. Pressure drop calculations for a typical system.
7.6. Hydraulics and rate of penetration.
7.7. Pressure surge* caused by pipe movement.
7.8. Air, gas, and aerated mud drilling.
 
Chapter 8. Factors Affecting Penetration Rate
8.1. Introduction.
8.2. Fundamentals of rocJt failure.
8.3. Rock characteristics.
8.4. Mechanical factors.
8.5. The effect of drilling fluid properties on penetration rate. 8.6. Hydraulic factors. 8.7. Other drilling methods.
 
Chapter 9. Rotary Drilling Techniques
9.1. Vertical drilling.
9.2. Directional drilling.
9.3. Fishing operations.
 
Chapter 10. Coring and Core Analysis
10.1. General coring methods and equipment.
10.2. Operational procedures.
10.3. Handling and sampling of core гесошу.
10.4. Routine core analysis.
10.5. Fundamental fluid distribution concepts — multiphase systems.
10.6. Special core analysis procedures.

10.7. Practical uses of core analysis data.

Комментарии (0)



Разрешённые теги: <b><i><br>Добавить новый комментарий: